## How to Remove an Insinkerator Hot Water Dispenser
### Safety Precautions
Before starting any work, ensure the following safety precautions are taken:
Turn off the water supply: Locate the water shutoff valves below the sink and turn off both the hot and cold water.
Unplug the appliance: Disconnect the electrical cord from the power outlet.
Drain the dispenser: Open the hot water faucet and allow the water to run until it stops.
Wear protective gear: Wear gloves and safety glasses to protect against hot water and sharp edges.
### Tools and Materials
You will need the following tools and materials:
Adjustable wrench or pliers
Phillips head screwdriver
Flat head screwdriver
Bucket or bowl
Towel or rag
### Step-by-Step Removal Instructions
1. Disconnect the Water Lines
Use an adjustable wrench or pliers to loosen the compression nuts connecting the water lines to the dispenser.
Hold the dispenser in place to prevent it from moving while unscrewing the nuts.
Place a bucket or bowl underneath the connections to catch any dripping water.
2. Detach the Electrical Wires
Locate the electrical wires connected to the dispenser.
Use a Phillips head screwdriver to loosen the screws securing the wires.
Carefully detach the wires and wrap them with electrical tape for safety.
3. Unscrew the Mounting Screws
Use a flat head screwdriver to unscrew the mounting screws securing the dispenser to the sink.
There may be several screws located around the base and sides of the dispenser.
4. Separate the Dispenser from the Sink
Once all the screws are removed, gently pull the dispenser away from the sink.
It may require some wiggling and maneuvering to free it from the mounting bracket.
5. Clean the Mounting Surface (Optional)
If desired, use a damp towel or rag to clean the mounting surface on the sink where the dispenser was located.
6. Inspect the Water Lines and Electrical Wires
Examine the water lines and electrical wires for any signs of damage or leaks.
Replace any damaged components as necessary.
### Reinstallation (Optional)
If you are replacing the dispenser with a new one, follow the instructions below to reinstall it:
Place the new dispenser onto the mounting bracket on the sink.
Secure it with the mounting screws.
Connect the water lines to the dispenser and tighten the compression nuts.
Connect the electrical wires and secure them with electrical tape.
Turn on the water supply and check for leaks.
Plug in the dispenser and test its functionality.
### Additional Tips
If you encounter any difficulties during the removal process, do not hesitate to contact a qualified plumber for assistance.
Always dispose of old or damaged appliances and components properly according to local regulations.
If the dispenser is leaking or malfunctioning, do not attempt to repair it yourself. Contact the manufacturer or a qualified technician instead.