## How to Install Voltas Water Dispenser
Installing a Voltas water dispenser is a relatively simple process that can be completed in a few minutes. By following the steps below, you can ensure that your dispenser is installed correctly and is ready to use.
### Tools and Materials You’ll Need
– Voltas water dispenser
– Phillips head screwdriver
– Adjustable wrench
– 1/4-inch drill bit
– 3/8-inch drill bit
– Safety glasses
### Step-by-Step Instructions
1. Choose a Location
The first step is to choose a location for your water dispenser. The location should be near a water source, such as a sink or refrigerator. It should also be a location where the dispenser will not be in the way.
2. Prepare the Location
Once you have chosen a location, you need to prepare it for the dispenser. This may involve drilling a hole in the countertop or wall for the water line. If you are drilling a hole in the countertop, be sure to use a drill bit that is the same size as the water line. If you are drilling a hole in the wall, be sure to use a drill bit that is slightly larger than the water line.
3. Connect the Water Line
Once the location is prepared, you need to connect the water line to the dispenser. To do this, first insert the water line into the hole that you drilled. Then, attach the water line to the water inlet valve on the dispenser. Use an adjustable wrench to tighten the connection.
4. Install the Dispenser
Once the water line is connected, you need to install the dispenser. To do this, first remove the four screws that are located on the bottom of the dispenser. Then, lift the dispenser into place and insert the screws into the holes. Tighten the screws until the dispenser is secure.
5. Test the Dispenser
Once the dispenser is installed, you need to test it to make sure that it is working properly. To do this, first turn on the water supply. Then, press the power button on the dispenser. The dispenser should start to dispense water.
Congratulations! You have now successfully installed your Voltas water dispenser.
### Troubleshooting
If you are having trouble installing your Voltas water dispenser, there are a few things that you can check.
– Make sure that the water line is connected properly. The water line should be inserted all the way into the hole that you drilled. The connection should also be tight.
– Make sure that the power cord is plugged in. The power cord should be plugged into a working outlet.
– Make sure that the dispenser is turned on. The power button should be in the “on” position.
– Make sure that the water supply is turned on. The water supply should be turned on at the source.
If you have checked all of these things and the dispenser is still not working, you may need to contact Voltas customer service.
### Tips
– Use a level to make sure that the dispenser is level before you install it. This will help to ensure that the dispenser is working properly.
– Clean the dispenser regularly to prevent the buildup of bacteria. You can clean the dispenser with a mild soap and water solution.
– Replace the water filter every six months to ensure that the water is clean and fresh.
### Conclusion
Installing a Voltas water dispenser is a simple process that can be completed in a few minutes. By following the steps in this article, you can ensure that your dispenser is installed correctly and is ready to use.