## How to Install a Bunn Water Dispenser
Installing a Bunn water dispenser is a relatively simple process that can be completed in a few hours. By following these step-by-step instructions, you can ensure that your dispenser is installed correctly and is operating properly.
### Tools and Materials
Before you begin, gather the following tools and materials:
– Bunn water dispenser
– Phillips head screwdriver
– Adjustable wrench
– Teflon tape
– Plumber’s putty
– Electrical outlet
– Water supply line (if not included with the dispenser)
### Step-by-Step Instructions
1. Choose a Location
– Select a location for the dispenser that is close to a water source and an electrical outlet.
– Ensure that the location is well-ventilated and has enough space for the dispenser to operate.
2. Prepare the Water Supply
– If your dispenser does not come with a built-in water supply line, you will need to purchase one.
– Connect the water supply line to the cold water supply valve under your sink.
– Wrap Teflon tape around the threads of the connection to prevent leaks.
3. Install the Dispenser
– Position the dispenser on the countertop and connect the water supply line to the inlet valve on the back of the dispenser.
– Use an adjustable wrench to tighten the connection.
– Apply plumber’s putty to the base of the dispenser and press it down firmly to secure it to the countertop.
4. Connect the Dispenser to Power
– Plug the dispenser into an electrical outlet.
– Turn on the power switch on the dispenser.
5. Prime the Dispenser
– Press and hold the “Hot” and “Cold” buttons simultaneously for 5 seconds.
– The dispenser will begin to dispense water.
– Allow the dispenser to run until water flows out of both the hot and cold faucets.
6. Adjust the Temperature Settings
– Use the “Hot” and “Cold” temperature dials to adjust the temperature of the dispensed water.
– Refer to the dispenser’s manual for recommended temperature settings.
7. Test the Dispenser
– Dispense a cup of hot water and a cup of cold water to test the temperature and flow rate.
– Make any necessary adjustments to the temperature settings or water supply connection.
### Troubleshooting Common Installation Issues
Leak at the Water Supply Connection
– Tighten the connection using an adjustable wrench.
– Replace the Teflon tape if necessary.
Dispenser Not Dispensing Water
– Ensure that the dispenser is plugged into an electrical outlet and the power switch is turned on.
– Check if the water supply line is connected properly.
– Press and hold the “Hot” and “Cold” buttons simultaneously for 5 seconds to prime the dispenser.
Dispenser Dispensing Hot Water Only
– Check if the “Hot” temperature dial is set too high.
– Adjust the “Cold” temperature dial to decrease the flow rate of cold water.
### Additional Tips for Installation
– Place a drip tray under the dispenser to catch any spills.
– Clean the dispenser regularly according to the manufacturer’s instructions.
– If you experience any issues with the installation or operation of the dispenser, refer to the user manual or contact Bunn technical support.
By following these instructions, you can install your Bunn water dispenser with confidence and enjoy fresh, filtered water for years to come.