## How to Install an Avanti Water Dispenser
### Tools and Materials You’ll Need
Avanti water dispenser
Wrench or spanner
Screwdriver
Measuring tape or ruler
Level
Teflon tape
Plumber’s putty
### Step-by-Step Installation Instructions
1. Choose the Installation Location:
Select a location for your water dispenser that is accessible and has a nearby cold water source.
Make sure there is enough space around the dispenser for easy access and maintenance.
Use a measuring tape or ruler to ensure the dispenser can fit comfortably in the desired location.
2. Mount the Bracket:
Place the mounting bracket on the wall at the desired height. Ensure it is level using a level tool.
Mark the screw holes on the wall.
Drill pilot holes at the marked points.
Insert screws into the pilot holes and tighten them to secure the bracket to the wall.
3. Connect the Water Line:
Shut off the water supply at the source.
Connect the 1/4-inch compression fitting on the water dispenser to the cold water supply line. Use Teflon tape on the threads to create a seal.
Tighten the compression fitting securely with a wrench or spanner.
Turn on the water supply and check for any leaks. If there are leaks, tighten the compression fitting further.
4. Install the Drip Tray:
Align the drip tray with the bracket and slide it into place.
Secure the drip tray in position by tightening the screws.
5. Mount the Dispenser:
Lift the water dispenser onto the bracket.
Align the holes in the dispenser with the screws on the bracket.
Insert screws into the holes and tighten them to secure the dispenser to the bracket.
6. Seal the Base:
Apply a bead of plumber’s putty around the base of the dispenser where it meets the countertop.
Smooth out the putty to create a seal and prevent water leakage.
7. Connect the Power:
Plug the water dispenser into a nearby electrical outlet.
8. Test the Dispenser:
Turn on the water dispenser and run water through all taps.
Check for any leaks or malfunctions.
Adjust the temperature settings to your desired level.
### Troubleshooting Tips
1. No Water Flow:
Check if the water supply is turned on.
Inspect the water line for any kinks or blockages.
Ensure the compression fitting is tightened securely.
2. Water Leakage:
Inspect the connections at the water line and the dispenser base for leaks.
Tighten any loose connections.
Apply additional plumber’s putty to any areas where water is seeping through.
3. Irregular Water Temperature:
Check if the temperature settings are set correctly.
Allow the dispenser to cool down or heat up fully before adjusting the temperature.
4. Noisy Operation:
Ensure the water dispenser is level and properly installed.
Check if there are any loose screws or connections.
Contact the manufacturer for assistance if the noise persists.
### Maintenance Tips
Clean the exterior of the dispenser regularly with a damp cloth.
Replace the water filter every 6-12 months or as recommended by the manufacturer.
Inspect and clean the drip tray periodically to prevent mold or bacteria buildup.
If the dispenser is not used for an extended period, drain the water lines and unplug the unit.
### Conclusion
Installing an Avanti water dispenser is a relatively straightforward process that can be completed in a few simple steps. By following the instructions carefully and using the proper tools and materials, you can enjoy fresh and cold water from your dispenser for years to come.