## How to Install an Avalon Water Dispenser
Installing an Avalon water dispenser is a relatively simple process that can be completed in a few hours. By following these step-by-step instructions, you can ensure that your dispenser is installed correctly and functioning properly.
Tools and Materials You’ll Need:
– Avalon water dispenser
– Adjustable wrench
– Plumber’s tape
– Drill (with 1/2-inch drill bit)
– Saw (for cutting the hole in the countertop)
– Screwdriver
– Electrical tape
### Step-by-Step Instructions:
1. Choose the Location:
– Select a location for the dispenser that is near a water source and has sufficient space for both the dispenser and the wastewater container.
– Ensure that the surface is level and can support the weight of the dispenser.
2. Prepare the Countertop:
– Measure and mark the location of the hole where the dispenser will be inserted.
– Drill a 1/2-inch hole through the countertop using the drill.
– Cut a hole in the countertop around the drilled hole using a saw. The hole should be large enough to accommodate the dispenser’s base.
3. Connect the Water Supply:
– Turn off the water supply to the sink.
– Connect the water supply line to the water inlet valve on the back of the dispenser. Use plumber’s tape to seal the connection.
– Turn the water supply back on and check for leaks.
4. Insert the Dispenser:
– Carefully lift the dispenser and insert it into the hole in the countertop.
– Make sure that the dispenser is level and fits snugly in the hole.
5. Secure the Dispenser:
– Tighten the lock nut on the underside of the countertop using an adjustable wrench.
– This will secure the dispenser in place.
6. Connect the Wastewater Container:
– Attach the wastewater container to the drain outlet on the back of the dispenser.
– Use electrical tape to secure the connection.
7. Connect the Power:
– Plug the dispenser into a grounded electrical outlet.
8. Test the Dispenser:
– Turn on the dispenser and allow it to run for a few minutes.
– Check for leaks and ensure that the water is dispensing properly.
9. Clean the Dispenser:
– Clean the dispenser according to the manufacturer’s instructions. This typically involves running a vinegar solution through the system to remove any impurities.
### Troubleshooting:
– Water is leaking from the dispenser: Check the connections to the water supply line and wastewater container. Make sure they are properly sealed with plumber’s tape.
– Water is not dispensing: Check that the water supply is turned on and that the dispenser is plugged into a power outlet. If the dispenser is still not dispensing water, there may be an issue with the water pump.
– The dispenser is making a noise: This could be due to air in the water lines. Run the dispenser for a few minutes to expel the air.
– The dispenser is not cooling the water: Check that the cooling unit is turned on and that the dispenser is properly filled with water. If the dispenser is still not cooling the water, there may be an issue with the cooling compressor.
By following these instructions, you can successfully install an Avalon water dispenser. If you encounter any problems during the installation process, please refer to the troubleshooting section or consult a qualified plumber.