## Step-by-Step Guide to Installing a Haier Water Dispenser
### Materials Required
– Haier water dispenser
– Phillips screwdriver
– Adjustable wrench
– Teflon tape
– Flex hose (if needed)
– Wall mounting screws (optional)
### Step 1: Unpack and Inspect the Dispenser
– Carefully unpack the Haier water dispenser and verify that all components are included.
– Inspect the dispenser for any damage or defects. If any damage is found, contact the manufacturer immediately.
### Step 2: Choose the Location
– Select a suitable location for the dispenser, considering the following factors:
– Proximity to a water source
– Easy access for refills and maintenance
– Sufficient clearance around the dispenser
### Step 3: Connect the Water Supply
– Turn off the main water supply.
– Locate the nearest cold water line and cut a section of pipe using a pipe cutter.
– Clean the cut ends of the pipe with sandpaper.
– Apply Teflon tape to the threads of a saddle valve.
– Install the saddle valve onto the pipe and tighten it securely using an adjustable wrench.
– Connect a flex hose to the saddle valve. The other end of the hose will be connected to the water inlet valve on the dispenser.
### Step 4: Install the Dispenser (Freestanding)
– If the dispenser is freestanding, skip this step.
### Step 5: Mount the Dispenser (Wall-Mounted)
– Mark the mounting holes on the wall using the provided template.
– Drill holes at the marked locations.
– Insert the wall mounting screws into the holes and tighten them partially.
– Hang the dispenser onto the screws and tighten them securely.
### Step 6: Connect the Flex Hose
– Connect one end of the flex hose to the water inlet valve on the dispenser.
– Connect the other end of the hose to the saddle valve or water line.
– Tighten both connections using an adjustable wrench.
### Step 7: Turn on the Water Supply
– Turn on the main water supply.
– Check for leaks at all connections. If any leaks are detected, tighten the connections accordingly.
### Step 8: Flush the System
– Open the hot and cold water faucets on the dispenser to flush out any impurities or contaminants in the water lines.
– Allow the water to run for a few minutes until it becomes clear.
### Step 9: Test the Dispenser
– Press the hot and cold water buttons to dispense water.
– Verify that the water temperature is correct.
– Check the water flow rate to ensure it is adequate.
### Step 10: Final Installation
– Plug the dispenser into a grounded electrical outlet.
– Place the water bottle or jug on the dispenser.
– Adjust the drip tray to the desired position.
### Additional Tips:
– Use a water filter to improve the taste and quality of the water.
– Regularly clean and maintain the dispenser according to the manufacturer’s instructions.
– If you encounter any problems with the dispenser, consult the user manual or contact a qualified technician.