## Cleaning Upright Honeywell Water Dispenser: A Comprehensive Guide
### Introduction
Maintaining a clean Honeywell water dispenser is crucial for optimal performance and ensuring the safety of the dispensed water. This comprehensive guide provides a step-by-step process for cleaning your upright Honeywell water dispenser effectively.
### Required Materials
– Mild detergent
– Soft cloth
– White vinegar (optional)
– Dish sponge
– Clean toothbrush
– Distilled water
### Disassembly and Cleaning
Step 1: Disconnect and Empty
– Unplug the dispenser and let it cool down if necessary.
– Empty the water reservoir completely by pressing the dispense button until all water is drained.
Step 2: Remove Reservoir and Lid
– Open the front door of the dispenser and lift the reservoir straight up to remove it.
– Remove the lid from the reservoir.
Step 3: Clean Reservoir and Lid
– Wash the reservoir and lid thoroughly with a mild detergent and warm water.
– Rinse them well and shake off excess water.
– If desired, soak the reservoir and lid in a solution of equal parts white vinegar and water for 30 minutes to remove any mineral deposits.
Step 4: Clean Exterior
– Wipe down the exterior of the dispenser with a soft cloth and mild detergent.
– Use a brush to clean the vents and any other areas that may accumulate dust.
Step 5: Clean Filter (Optional)
– If your dispenser has a replaceable filter, remove it and clean it according to the manufacturer’s instructions.
Step 6: Clean Reservoir Opening
– Use a clean toothbrush to gently scrub around the reservoir opening in the dispenser.
– This will remove any residue or water droplets that may attract bacteria.
### Reassembly and Sanitization
Step 7: Reposition Reservoir
– Place the clean reservoir back into the dispenser and ensure it is properly seated.
Step 8: Reattach Lid
– Put the lid back on the reservoir and secure it.
Step 9: Sanitize Reservoir
– Fill the reservoir with distilled water to the maximum fill line.
– Add 1 teaspoon of white vinegar to the water.
– Run the water through the dispenser until the water is clear.
Step 10: Rinse and Fill
– Empty the reservoir and rinse it thoroughly with clean water.
– Fill the reservoir with fresh distilled water.
Step 11: Reconnect and Test
– Plug the dispenser back in and allow it to cool for 30 minutes before using.
– Test the dispenser to ensure it is working properly.
### Tips for Maintaining a Clean Dispenser
– Clean the dispenser regularly, especially after periods of inactivity.
– Replace the filter according to the manufacturer’s recommendations.
– Avoid using harsh chemicals or abrasive cloths on the dispenser.
– Keep the dispenser in a dry and well-ventilated area.
– If you notice any unusual taste or odor from the dispensed water, clean the dispenser thoroughly.
### Conclusion
By following these steps, you can effectively clean your upright Honeywell water dispenser and maintain its optimal performance. Regular cleaning is essential for ensuring the safety and quality of the dispensed water.