## How to Install a Breckenridge Kitchen Sink
### Introduction
The Breckenridge kitchen sink is a popular choice for homeowners due to its sleek design and durable construction. Installing a Breckenridge sink is a relatively straightforward process, but it is important to follow the instructions carefully to ensure a proper installation.
### Tools and Materials
Before you begin, you will need to gather the following tools and materials:
– Breckenridge kitchen sink
– Sink strainer
– Plumber’s putty
– Adjustable wrench
– Putty knife
– Measuring tape
– Level
– Pencil
– Hacksaw or reciprocating saw (if necessary)
### Step 1: Prepare the Sink Cabinet
* Start by turning off the water supply to your kitchen.
* Remove the old sink from the cabinet, if necessary.
* Clean the sink cabinet thoroughly and remove any debris.
* Measure the opening in the sink cabinet and compare it to the dimensions of the Breckenridge sink.
* Make any necessary adjustments to the cabinet opening, such as cutting it larger or adding shims to make it smaller.
### Step 2: Install the Sink Strainer
* Apply a small amount of plumber’s putty to the rim of the sink strainer.
* Place the strainer over the drain hole in the sink.
* Tighten the strainer nut by hand until it is snug.
### Step 3: Apply Plumber’s Putty to the Sink
* Roll out a rope of plumber’s putty and place it around the rim of the sink.
* Make sure the putty is evenly distributed and creates a seal around the edge of the sink.
### Step 4: Position the Sink in the Cabinet
* Carefully lift the Breckenridge sink and position it in the cabinet opening.
* Align the sink with the center of the opening and make sure it is level.
### Step 5: Secure the Sink
* Reach under the sink and tighten the mounting clips.
* Start by tightening the clips on the front of the sink, then move to the back.
* Tighten the clips until the sink is secure, but do not overtighten.
### Step 6: Connect the Water Supply Lines
* Connect the hot and cold water supply lines to the corresponding valves on the Breckenridge sink.
* Use an adjustable wrench to tighten the connections.
### Step 7: Connect the Drain
* Attach the flexible drain hose to the drain outlet on the Breckenridge sink.
* Tighten the hose clamp using an adjustable wrench.
### Step 8: Test the Sink
* Turn on the water supply and check for any leaks.
* If there are any leaks, tighten the connections until they stop.
### Tips for Installing a Breckenridge Kitchen Sink
– Use a level to make sure the sink is installed evenly.
– Do not overtighten the mounting clips, as this can damage the sink.
– If you are cutting the countertop to fit the sink, use a hacksaw or reciprocating saw and wear safety glasses.
– Apply a thin bead of silicone caulk around the edge of the sink to prevent leaks.
– If you need to make any adjustments to the sink after it is installed, use a putty knife to remove the plumber’s putty and make the necessary changes.
### Conclusion
Installing a Breckenridge kitchen sink is a relatively easy task that can be completed in a few hours. By following the instructions carefully and using the right tools and materials, you can ensure a successful installation.